Wintriss SmartPAC PRO Servo, User Manual

Page: 73 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 4
– Initialization Mode
73
POSITION SENSOR
(INITIALIZATION
– POSITION SENSOR)
This item allows you to select certain parameters for the press. Parameters are set on the screen
shown in Figure 4-3. The following sections show you how to set each parameter.
Figure 4-3. Position Sensor Screen
Position Sensor Mode
(INITIALIZATION
– POSITION SENSOR)
SmartPAC PRO Servo does not use a position sensor, and this item is set to “DISABLED” by default.
If POSITION SENSOR MODE has been inadvertently set to “ENABLED,” the “Position sensor
incorrect” message displays (see page 188 for details). To correct this problem, do the following:
1. On the Position Sensor screen and with the POSITION SENSOR MODE setting selected, press
ENTER to toggle the setting from “ENABLED” to “DISABLED.”
2. Press Back when you are done.
Resolver Motion Mode (Normal Motion
– Link Motion)
(INITIALIZATION
– POSITION SENSOR)
SmartPAC PRO Servo does not use a resolver. Leave this option set to “NORMAL MOTION,” its
default setting. The setting has no effect on the operation of your press.
Angle Wheel Rotation (Clockwise
– Counterclockwise)
(INITIALIZATION
– POSITION SENSOR)
Leave this item set to “CW” (Clockwise), its default setting.