Wintriss SmartPAC PRO Servo, User Manual

Page: 200 / 228

1147100 SmartPAC PRO Servo User Manual
200 Index
sensors, types, 22
DSI 2. See DiPro Sensor Interface 2 (DSI 2)
E
edit tool, 106
e-mail.
See network, See messaging
emergency stop (e-stop), description, 130
ENTER button, 68
error event log, 192
errors.
See fault messages
E-stop. See emergency stop
F
fault messages
“Batch # counter preset reached”, 187
“Fault message for red sensors, 191
“File Not Found”, 192
“Good parts counter preset reached”, 187
“Green constant fault”, 190
“Green quick check sensor actuated outside ready”,
190
“Green sensor actuated late”, 189
“Green sensor failure”, 190
“Green sensor missed”, 189
“Green special fault”, 190
“Inboard ram test failure”, 188
“Linear transducer output is not correct.”, 187
“Loss of Communication at Address X”, 191
“No tool number has been loaded”, 188
“One of the sensor auto enable counters is greater
than 99”, 191
“Position sensor incorrect”, 188
“Strokes counter preset reached”, 187
“The press cycle was interrupted before upper or
lower limits were reached”, 191
“This N/O sensor is grounded”, 190
“Tool number table checksum error”, 188
error/event log, using to troubleshoot, 192
E-Stop errors, 188
responding to, 186
fault messages, 186
Favorite button, 68
features
optional, 21, 25
standard, 20
firmware, updating, 104
G
global cams. See cams, global
good parts counter, 115
H
Help button [ ? ], 68
hits counter, 115
I
Initialization mode, 71
main menu, 71, 72
input check
switch, setting, 42, 43
wiring, 41
wiring table, 42
installation
guidelines, 28
overview, 30
remote HMI, 34
installed options
viewing, 75
L
language (optional), selecting, 77
linear sensor.
See linear transducer
linear transducer, 39
Balluff, dimensions, 194
Balluff, installing, 193
Balluff, wiring, 194
MTS DC wiring, 39
MTS wiring, 39
MTS wiring illustration, 39
MTS wiring table, 39
MTS, dimensions, 36
MTS. installing, 35
offset value, 86
sensor resolution, 86
setup, 84
setup definitions, 86
units, 86
upper limit, 86
wiring, 37
zero value, 86
load tool
Program mode, 106, 110
Run mode, 161
M
messaging, 182
email, sending, 182
e-mail, sending to Wintriss Technical Support, 184
N
network
change settings, 100
e-mail, 99
e-mail, setup, 100
IP address, setting static, 43
press type, SmartView, 100
setup, 99
SmartView, 100
SmartView, press type, 100
O
operating modes
entering and exiting, 65
overview, 23