Wintriss SmartPAC PRO Servo, User Manual

Page: 168 / 228

1147100 SmartPAC PRO Servo User Manual
168 Chapter 6
– Run Mode
NOTICE
ARE YOU LOCKED OUT?
Access to items on the Die Protection Menu may be limited to Program mode or may require a
password. The security access settings in Initialization mode determine when changes can be
made. See Table 4-5, page 94.
The DIE PROTECTION item is split into DIPROPAC 1-16 and DIPROPAC 17-32 entries when
DiProPAC 32 is an installed option (see
Adjusting DiProPAC 32 Sensors , page 172).
To change programmed settings on the Die Protection Menu, you first select a sensor from the list of
sensors displayed. Sensors set to UNUSED in Program mode are not shown.
NOTICE
FOR MORE INFORMATION
For a detailed description of the different types of sensors available in SmartPAC PRO Servo with
die protection, refer to
Understanding Sensor Terminology , page 121. Refer to Programming
Sensor Settings , page 125, for detailed instructions on modifying sensors..
Adjusting the Ready Signal for Green Sensors
When you select a green, green quick check, or green constant sensor on the Die Protection Menu, the
Ready Signal Programming screen, shown in Figure 6-11, displays.
The functionality of this screen differs slightly from that of the Ready Signal Programming screen in
Program mode. When you run the press, the angles at which the selected sensor turns on and off on
each stroke are shown in the window labelled SENSOR at the right of the screen, and the number of
degrees that the sensor is on is represented graphically by a green arc on the ram angle clock. These
displays allow you to fine-tune the Ready signal settings made in Program mode.
Figure 6-11. Ready Signal Programming Screen
Another difference is that the On and Off cursors move around the ram angle clock more slowly when
you press the cursor keys, enabling you to set Ready On and Ready Off angles more precisely.