Wintriss SmartPAC PRO Servo, User Manual

Page: 119 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 5
– Program Mode
119
1. On the Counter Mode Selections screen, move the highlight bar to the increment angle value for
the counter you want to adjust (e.g., Batch 2), then press ENTER. The Numeric Entry window
displays.
2. Key in a new increment angle value, following the directions in the window, then press ENTER.
The value you entered is displayed on the Counter Mode Selections screen.
3. Repeat steps 1 and 2 for other counters, as necessary.
Setting Parts per Stroke or Strokes per Part
SmartPAC PRO Servo allows you to control how the Strokes and Good Parts counters increment in
relation to each other. You can specify the number of parts made during each stroke, in which case
the Good Parts counter will increment in multiple units (e.g., 2, 3, etc.) for each increment of the
Strokes counter. This setting is useful in multiple-up die applications. Conversely, you can specify the
number of strokes required to make each part, causing the Good Parts counter to increment only once
for multiple increments (e.g., 2, 3, etc.) of the Strokes counter. This setting is useful in die
applications with a gagged cutoff.
To set the number of parts made per stroke or number of strokes required to make a part, do the
following:
1. On the Counter Mode Selections screen, press ADVANCED MODES. The Advanced Counter
Mode Selections screen, Figure 5-16, displays.
Figure 5-16. Advanced Counter Mode Selections Screen
2. Select the value displayed for the item you want to program (i.e., PARTS MADE PER EACH
STROKE or STROKES TO MAKE EACH PART). The Numeric Entry window displays.
3. Key in the value you want, following the directions in the window, and press ENTER. The value
you keyed in displays in the field you selected in step 2.
4. Press RESET to return to the Counter Mode Selections screen.