Wintriss SmartPAC PRO Servo, User Manual

Page: 96 / 228

1147100 SmartPAC PRO Servo User Manual
96 Chapter 4
– Initialization Mode
Examples
You want to prevent the operator from loading a tool number in Run mode. To accomplish this,
set the security access for LOAD TOOL # to PROGRAM MODE ONLY. With this setting, a tool
can be loaded only when the Program/Run key is switched to PROG.
You want to give only certain individuals the ability to adjust cams. To accomplish this, set
ADJUST CAMS to PASSWORD REQUIRED, and give these individuals the password. With
security access set in this way, the cams cannot be adjusted without the user entering the
correct password.
Changing Passwords
SmartPAC PRO Servo allows you to set up to four different passwords:
•
General Password–Provides access to all SmartPAC PRO Servo menus and settings unless one or
more of the following specific passwords is also required
•
Init. Password–Provides access to the Main Initialization Menu
•
PM Password–Provides access to the PM (Preventive Maintenance) Monitor setup in Program
mode
•
Tool Template Password–Provides access to the Tool Template (see page 109)
Passwords must be numeric and can be from one to four digits in length.
NOTICE
DEFAULT PASSWORDS
Your SmartPAC PRO Servo comes from the factory with all passwords set to the default password
“1234.” If you have upgraded your SmartPAC PRO Servo in the field, your passwords may be
different.
To change passwords, perform the following steps:
1. On the Security Access Menu (Figure 4-21), press the CHANGE PASSWORDS button to display
the Set Passwords Menu (Figure 4-23).