Whirlpool ADVANTECH CAE2761K, Installation, Operation And Service Instructions

Page: 141 / 178

6-13
Stack Dryers
Models CSP2770K & CSP2771K
TIME AND DATE CLOCK
The time and date are not set at the factory.
The electronic control uses a battery to run the
clock. If the wire harness at connector P2 is
unplugged, the battery is disconnected and the
time and date must be reset. The battery has a
life of approximately ten years.
ACCESS MODE
Using a Palm

Handheld With Software
1. Use Service Routine software.
2. To minimize possible infrared (IR) interfer-
ence from other sources, hold the handheld
at a 90
°
angle no more than one inch from
the display, pointed directly at the right side
of the vend-price LED display of each unit.
3. After selecting the command, the HIGH
TEMPERATURE LED begins blinking to
confirm command was received. The
machine’s lifetime cycle count now shows
on display.
If a Palm

Handheld With Software
Is Not Available
1. Open control panel on front of collar. This
panel may be locked and require a key.
2. Push and release the service button lo-
cated on the right side of the control board.
3. The HIGH TEMPERATURE LED begins
blinking to confirm that the button was
pushed. The machine’s lifetime cycle count
now shows on display.
NOTE: The display automatically returns to the
vend-price after 1 minute of inactivity.
RUNNING THE MACHINE WITHOUT
A COINSLIDE, COINDROP, OR
SMART CARD
1. Perform all steps under “Access Mode”.
2. Push and release keypad position 3 (LOW).
3. Dryer is now ready for use as if money was
used.
IMPORTANT SETUP
INFORMATION
Using a Palm

Handheld
The electronic control is factory preset to ac-
cept commands from a Palm

handheld
equipped with the appropriate Whirlpool Man-
agement Software. If a handheld will not be
used, the handheld functionality must be dis-
abled as part of the control set up. Failure to
disable handheld functionality may result in un-
authorized machine access. For details, see the
OWNER SETTINGS table “P ACc”, page 6-17.
Money Acceptors
This electronic control can use a coinslide or
coindrop, (single or dual), and/or a SMART
Card money acceptor, which are available
from independent suppliers of these devices.
The electronic control is used on many differ-
ent models, including metercase models. On
this machine, the electronic control is factory
preset to accept input only from a coinslide
device.
To instruct the control to accept inputs from
other devices, or to disable input from a coin-
slide, see the OWNER SETTINGS table (droP,
SLidE, CArd), on page 6-16. These settings
can also be made using a Palm

handheld with
the appropriate Whirlpool Management Soft-
ware.
Device Connections:
Refer to the installation instructions from the
supplier of each device. Refer to the wiring
diagram for this product.
• Coinslide connection is made via the wire
harness provided.
• Coindrop connection to a single or dual
coindrop is made via the wire harness
provided in the device, plugged into the
electronic control at P-10 COIN 1 and
P-12 COIN 2.
• Connection to a SMART Card device is
via the wire harness provided with the
device, and plugged into the electronic
control at P-11 AUX.