Whirlpool ADVANTECH CAE2761K, Installation, Operation And Service Instructions

Page: 169 / 178

WHIRLPOOL COMMERCIAL ONL WHIRLPOOL COMMERCIAL ONL
WHIRLPOOL COMMERCIAL ONL WHIRLPOOL COMMERCIAL ONL WHIRLPOOL COMMERCIAL ONLYYYYY
LAUNDRY PRODUCTS REFRIGERATION PRODUCTS KITCHEN PRODUCTS
COMMERCIAL POINTERS: www.whirlpoolcorp.com/cltpsc, TECHNICAL INFORMATION, SERVICE POINTERS
ALL ST ALL ST
ALL ST ALL ST ALL STA
A
A A ACK DRYERS
CK DRYERS
CK DRYERS CK DRYERS CK DRYERS, ALL MODELS
, ALL MODELS
, ALL MODELS , ALL MODELS , ALL MODELS
THA THA
THA THA
THAT BEGIN WITH CS T BEGIN WITH CS
T BEGIN WITH CS T BEGIN WITH CS
T BEGIN WITH CS, CSP , CSP
, CSP , CSP
, CSP
L8178268 L8178268 L8178268 L8178268 L8178268
October 2002 October 2002 October 2002 October 2002 October 2002
3 3
3 3 3
Income decreasing from stack dryer, or upper dryer loose
from collar assembly.
COMPLAINT:
CAUSE:
The factory ½” Hex head bolts that secure the upper dryer
to the collar assembly have been removed allowing un-
authorized access to the collar.
SOLUTION:
Install Security Kit Part # 285875
Kit Contains: Screw (2)
Cotter Pin (2)
Instruction Sheet (1)
This kit is designed to prevent unauthorized access to the
collar and meter case assembly on stack dryers by
replacing the original factory ½” hex head bolts that secure
the upper dryer to the collar with the T40 Torx head bolts
and retaining clips. After the kit is installed the upper dryer
can only be removed by first gaining access to the control
panel assembly with the proper key. The contents of this
kit are factory installed on all stack dryers after serial
numbers that begin with ML50. The kit will retrofit to all
stack dryer models.
PROCEDURE:
1. Disconnect electrical supply to unit.
2. Remove the lower access panel on the upper dryer
unit by inserting a putty knife approximately 3” in from
the sides of the unit to release the spring clips
(Figure 1). Pull the top of the panel forward to release.
3. Remove the hex head bolts from the front two corners
of the upper dryer (Figure 2).
FIGURE 1
FIGURE 2
4. Replace the factory installed hex head bolts with the
T40 screws included in this kit and tighten in place.
(continued)