Whirlpool ADVANTECH CAE2761K, Installation, Operation And Service Instructions

Page: 20 / 178

2-6
13. Screw the feet into the correct holes at the
front corner of the washer until the nuts
touch the washer.
NOTE: Do not tighten the
nuts until the washer is level, step 17.
14. Tilt washer backward and remove the wood
block. Gently lower washer to floor. Move
washer to its permanent location. Remove
cardboard or hardboard from under washer.
15. Tilt washer forward raising back legs 1
″
(2.5 cm) off of floor. To adjust rear leveling
legs, gently lower washer to floor.
9. Before attaching water inlet hoses, run water
through both faucets into a bucket. This will
get rid of particles in water lines that might
clog hoses. Mark which is the hot water
faucet.
10. Attach bottom hose (inlet marked “H”) to
hot water faucet. Attach top (inlet marked
“C”) to cold water faucet. Tighten coupling
to faucet by hand, then use pliers to make
final two-thirds turn.
11. Prop up the front of the washer about 4
″
(10.2 cm) with a wood block, or similar
object. The block needs to support the
weight of the washer.
12. Screw the locknut onto each foot to within
1
″
(2.5 cm) of the base.
2.5 cm
(1
″
)