Whirlpool ADVANTECH CAE2761K, Installation, Operation And Service Instructions

Page: 91 / 178

4-33
REMOVING THE CABINET
c) Slide the top forward to release if from
the two front side panel clips, and re-
move the top from the unit.
Side
Panel
Clips
Continued on the next page.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
3 Screws
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. To remove the dryer top:
a) Slide the console to the front of the unit
slightly, then rotate it back and place it
in the service position.
b) Remove the three rear hex-head screws
from the top.
Hex-Screws
Torx Screws W/Flat Washers
Front Panel
4. To remove the lower service access
panel,
use a putty knife, and pry down on
the upper retaining clips while pulling for-
ward on the lower service access panel,
and remove the panel.
Clip
Lower Service
Access Panel
5. T o remove the front panel:
a) Remove the lower service access panel
(see step 4).
b) Remove the two bottom hex-head
screws and the two T-15 Torx screws
and flat washers from the top of the
front panel.
Pry
Down
Clip