Whirlpool ADVANTECH CAE2761K, Installation, Operation And Service Instructions

Page: 107 / 178

4-49
5. To remove the high-limit thermostat or
the thermal cutoff:
a) Disconnect the wires from the high-
limit thermostat or the thermal cutoff.
b) Remove the two hex-head screws.
High-Limit Thermostat
(Red-White & Black Wires)
Heater Terminal Block
(Red & Red-White Wires)
Thermal Cutoff
(Red & Black Wires)
REMOVING THE HEATER, THE HIGH-LIMIT
THERMOSTAT, & THERMAL CUTOFF
(ELECTRIC DRYERS ONLY)
1. Unplug dryer(s) or disconnect power.
2. Remove the lower service access panel
(see step 4 on page 4-33 for the proce-
dure).
4. To remove the heater :
a) Remove the two wires from the termi-
nal block (see bottom photo).
b) Remove the hex-head screw from the
heater housing, and slide the heater
out of the duct.
High-Limit Thermostat,
Thermal Cutoff, & Heater Area
3. Remove the hex-head screw from the
heater shield and remove the shield.
Heater
Shield
Screw
Heater Housing
Screw
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING