Whirlpool ADVANTECH CAE2761K, Installation, Operation And Service Instructions

Page: 69 / 178

4-11
REMOVING THE PUMP, MOTOR START CAPACITOR, & MOTOR
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
1. Unplug washer or disconnect power.
2. Remove the two T-20 Torx screws from
the bottom of the front panel.
3. To remove the front panel, pull the bottom
forward to release it from the two top
retaining clips, and remove the panel.
4. To remove the pump:
a) Release the two pump spring clips and
pull the pump away from the motor.
b) Place a container near the two pump
hoses to catch the water, then remove
the clamps from the inlet and outlet
hoses, and pull them off the pump.
Front Panel
T-20 Torx Screws
Pump Inlet Hose
Pump Outlet Hose
Release Spring Clips
Pump
Motor
REASSEMBLY NOTE: Position the pump on
the motor shaft with the feet in the bracket
indents (circled below).
NOTE: The pump, motor start capacitor, and
motor can more easily be accessed by tilting
the washer back, or by laying it on its rear
panel.
Motor Start
Capacitor
Retaining Clips
Continued on the next page.