Whirlpool ADVANTECH CAE2761K, Installation, Operation And Service Instructions

Page: 84 / 178

4-26
Freestanding Dryers
REMOVING THE CONSOLE COMPONENTS
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Remove the two T-15 Torx screws from
the console.
4. Slide the console to the front of the unit
slightly, then rotate it back and place it in
the “service” position.
T-15 Torx Screws
5. To remove the ADVANTECH

control
board:
a) Disconnect the board connectors at
P1, P4, P8, and P11.
b) Disconnect the four wires at the dryer
motor relay K1 (RD & RD), and dryer
heater relay K2 (BU & BK).
c) Disconnect the green ground wire from
terminal P6.
d) Remove the six 5/16
″
hex-head screws
from the board and remove the board.
6. To remove the display board:
a) Remove the ADVANTECH

control
board (see step 5).
b) Disconnect the connector from the dis-
play board at P1.
c) Unlatch the display board from the
holder and remove it.
Control Board And Display Board
(Below Control Board)
Screw (1 of 6)
Relays
P1
P4
P8 P11
Ground Wire
ADVANTECH

Control Board
Display Board
P1
Latch
K2
K1
Card Reader
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING