T A L K S W I T C H I N S T A L L A T I O N
5
INSTALLING THE TALKSWITCH MANAGEMENT SOFTWARE
Installing the software
1. If the TalkSwitch unit is connected to a USB cable, disconnect the cable.
2. Turn on your computer and insert the TalkSwitch CD into your CD drive. The install program
starts automatically.
3. Click
NEXT
and follow the instructions.
4. If the TalkSwitch unit was connected to a USB cable, reconnect the cable.
If you are upgrading from TalkSwitch configuration software 5.00, this concludes the
installation procedure.
If you are upgrading from TalkSwitch configuration software 4.10, the
Found new hardware
icon will appear, followed by the USB driver installation wizard.
a) Proceed with the USB driver installation by clicking
Next
.
b) Once the USB driver files have been installed, click
Finished
.
c) Once the USB driver installation is complete, start the TalkSwitch management software.
d) When the
Connection
window appears, select
USB
, and then click
Connect
. The Data
LED on the TalkSwitch unit will blink when the connection is successful.
Port
Purpose
MUSIC
The music connector is a 1/8” (3.5mm) mono phono jack used as an audio
input for music on hold.
PA
The PA (public address) connector is a 1/8” (3.5mm) mono phono jack used
as an audio output for overhead paging, voicemail screening and music
on hold.
LAN
The LAN connector is an RJ-45 jack used for connection to a PC, connection
of IP extensions, connection of VoIP lines, and unit-unit networking.
There are three green LEDs on the right of the LAN port. The top LED
indicates network synchronization (connection), the middle LED indicates
data Rx (receiving data), and the bottom LED indicates data Tx
(transmitting data).
E1–E8
The extension connectors are RJ-11 jacks for analog extensions.
L1–L8
The line connectors are RJ-11 jacks for telephones lines.
USB
The USB connector is a B jack for connecting to a PC.
MEMORY SLOT
The memory slot on the side of the enclosure is a socket used with
TalkSwitch memory cards. Memory cards are not available in some markets.
POWER
The power connector is a receptacle rated at 16 VAC/2.0 A for connecting
the supplied AC adapter input line.
The latest version of the TalkSwitch software can be downloaded from the support section
at
http://global.talkswitch.com
.
