Steris RELIANCE 400, Operator'S Manual

Page: 92 / 106

6-8
122994-513 Operator Manual Routine Maintenance
6.8 Verify Power Doors
Verify operation of vertical sliding doors. Verify door operates
smoothly. Refer to
S
ECTION
7, T
ROUBLESHOOTING
, if door does not
operate smoothly.
Verify operation of each door safety switch as follows:
1. Wearing appropriate Personal Protective Equipment (PPE),
attempt to initiate a cycle with load side door open.
2. Close door and start a cycle. Wearing appropriate Personal Pro-
tective Equipment (PPE), slowly open door to verify operation of
automatic stop.
3. Repeat for unload side door.
6.9 Changing Printer
Paper Roll
See Figure 6-1.
NOTE: Do not operate printer without paper.
1. Open printer door.
2. Grasp remaining paper and pull it upward and out of printer.
3. Remove take-up spindle from its drive mechanism by pulling it to
left.
4. Remove paper roll from take-up spindle and set empty take-up
spindle aside.
5. Lower platen and remove lower paper spindle by pulling it
straight forward.
6. Place new paper roll onto lower spindle with paper feeding
downward from back of paper roll.
NOTE: Verify paper roll is positioned correctly. Thermal printer
does not print if paper roll is inserted backward. Use only STERIS
thermal paper (P129359-008). Damage to printer mechanism can
occur if paper of different width or thickness is used.
7. Place lower spindle (with new paper roll) back into position by
pressing from front until it snaps into place.
8. Pull 4 or 5 inches (10 to 13 cm) of paper out from roll and tear
corners off end.
9. Slide tab of paper roll into printer from back (with platen still in
down position) until it exits from front of printer.
10. Grasp tab of paper, pull up 10 to 12 inches (25 to 30 cm) of
paper and feed this paper through opening in platen.
WARNING – BURN HAZARD:
Wear appropriate Personal Pro-
tective Equipment (PPE) and
open door slowly if it is neces-
sary to open during a cycle. Hot
water/steam may be sprayed
through door opening when
verifying automatic stop while
washer is operating.
WARNING–PERSONAL INJURY
HAZARD: Risk of pinch point
between door and upper
panel. Do not push on top
portion of doors; do not push
on door when door is rising;
do not push on door when
door is jammed.