Steris RELIANCE 400, Operator'S Manual

Page: 47 / 106

4-17
Operating Instructions Operator Manual 122994-513
After a one-minute delay, if POWER-OFF/STANDBY is left in
OFF/STANDBY position, sump and optional pure water tank are
drained for two minutes. If option applies, drain discharge
cooldown system cools effluents before water is sent to drain.
Printer records:
STANDBY CYCLE START
2:51:32P
and display shows:
3. When cycle is completed and control goes into Standby mode,
interior chamber light remains
ON . Printer records:
STANDBY CYCLE END
2:53:32P
and display shows:
4. To perform maintenance on washer, position power switch,
located behind upper service panel, to OFF .
5. Position building electrical disconnect switch (circuit breaker) to
OFF and close building supply lines.
6. Clean unit as described in S
ECTION
6, R
OUTINE
M
AINTENANCE
.
7. Ensure building electrical disconnect switch and power switch
are positioned to ON after completion of cleaning and minor
maintenance procedures.
NOTE: Leaving power switch to OFF position overnight shortens
life span of battery backed-up control memory.
STANDBY CYCLE TIME
LEFT = 02:00
00:00:00 P