Steris RELIANCE 400, Operator'S Manual

Page: 63 / 106

5-11
Cycle and Control Value Programming Operator Manual 122994-513
4. When desired cycle name is flashing, press CHANGE VALUES
touch pad to access Change Values mode. Display shows:
__ indicates flashing position
To change cycle name, press CURSOR arrows (left or right) to
select position and VALUE arrows (up or down) to select
desired letter, number, punctuation or space. Cycle name can
be a maximum of nine characters, including spaces.
5. Press CHANGE VALUES touch pad. Change Values menu
screen appears:
__ indicates flashing position
6. Press CURSOR arrows (left or right) or VALUE arrows (up or
down) to select ADD function:
__ indicates flashing position
7. Press CHANGE VALUES touch pad to confirm ADD function
selection. Create Treatment screen appears:
__ indicates flashing position
NOTE: If only one treatment is programmed in the cycle, or if it is
possible to add only one treatment type, display goes directly to
Scroll Treatment to Add screen:
To select position in cycle where treatment is added, press
VALUE arrows (up or down) to scroll through treatments until
treatment name flashes.
IMPORTANT: If Pre-Wash treatment has been deleted, it is not
possible to add a treatment before Wash treatment. Control does
not allow restoring Pre-Wash treatment into cycle. In this case,
erase whole cycle and create a new one starting with a Pre-Wash
treatment so you can add desired treatments after Pre-Wash
treatment.
CHANGE CYCLE NAME
MEDIUM
MODIFY ADD
REMOVE EXIT
MODIFY ADD
REMOVE EXIT
CREATE TREAT. AFTER
PRE-WASH 1
CHANGE
VALUES
CURSOR VALUE
CHANGE
VALUES
CURSOR
VALUE
CHANGE
VALUES
VALUE