Steris RELIANCE 400, Operator'S Manual

Page: 68 / 106

5-16
122994-513 Operator Manual Cycle and Control Value Programming
7. Press CHANGE VALUES touch pad to confirm temperature
selection. Pre-Wash Time Value screen appears:
__ indicates flashing position
To enter Pre-Wash treatment time, press CURSOR arrows (left
or right) to select position and VALUE arrows (up or down) to
select desired number (0-9). Treatment time is input in minutes
and seconds within a range of 0-15 minutes and 0-99 seconds.
8. Press CHANGE VALUES touch pad to confirm time entry.
Change Values menu screen appears:
__ indicates flashing position
9. At this point, operator has option to either continue in Change
Values Mode, or to save values and exit Change Values mode.
• To exit Change Values mode, press SAVE VALUES . Control
saves changed values and returns screen to selected Cycle
menu.
• To continue in Change Values mode, press CURSOR
arrows (left or right) or VALUE arrows (up or down) to
select function. Press CHANGE VALUES touch pad to con-
firm selection and initiate function program.
5.7 Removing
Treatments From
Cycles
REMOVE function of the Change Values mode is used to delete
treatments from a programmed cycle.
The following procedure and flowchart (see Figure 5-6) show, as an
example, the procedure for deleting Pre-Wash treatment from a
cycle.
1. Set POWER-OFF/STANDBY switch, located behind printer
door, to POWER . Unit name temporarily appears on screen,
then screen displays first Cycle menu:
__ indicates flashing position
NOTE: To scroll through available Cycle menus, press CYCLE
MENU touch pad.
PRE-WASH
XX:XX
MODIFY ADD
REMOVE EXIT
CHANGE
VALUES
CURSOR VALUE
CHANGE
VALUES
SAVE
VALUES
CHANGE
VALUES
CURSOR
VALUE
LIGHT MEDIUM
HEAVY CYCLE 4