Steris RELIANCE 400, Operator'S Manual

Page: 102 / 106

7-8
122994-513 Operator Manual Troubleshooting
15. Alarm sounds and display shows:
(CYCLE NAME) (WATER TYPE)
CYCLE STOPPED
Alternating with:
ALARM: (PUMP NAME)
DETERGENT EMPTY
Printout message:
ALARM: (PUMP NAME) HH:MM:SS
DETERGENT EMPTY
1. Empty chemical container. Press ALARM REPLY touch
pad to silence alarm buzzer. Install new supply and press
CYCLE/START touch pad to resume operation (refer to
S
ECTION
6.6 ).
2. Low level sensor out of container. Press ALARM REPLY
touch pad to silence alarm buzzer. Insert level sensor in
container and press
CYCLE/START touch pad to resume
operation (refer to S
ECTION
6.6 ).
3. If condition reoccurs, call STERIS.*
16. Load side door was opened during cycle
processing. Alarm sounds and display
shows:
ALARM: LOAD DOOR
OPEN DURING PROCESS
Printout message:
ALARM: LOAD DOOR OPEN HH:MM:SS
DURING PROCESS
1. Press ALARM REPLY touch pad to silence alarm buzzer.
2. Close load side door and press CYCLE/START touch pad
to resume operation.
3. If condition reoccurs, call STERIS.*
17. If washer is equipped with power
door:
load side door remains closed
after DOOR OPEN touch pad was
pressed. Alarm sounds and display
shows:
ALARM: LOAD DOOR
DID NOT OPEN
Printout message:
ALARM: LOAD DOOR HH:MM:SS
DID NOT OPEN
1. Air supply valves are closed or air pressure is below specifi-
cations. Press
ALARM REPLY touch pad to silence alarm
buzzer. Open building and washer air supply valves and
press
DOOR OPEN touch pad on load side control panel
to open door.
2. Load door stayed closed after DOOR OPEN was pressed.
Proceed as follows:
a. Press ALARM REPLY touch pad to silence buzzer.
b. Press DOOR CLOSE touch pad.
c. Press DOOR OPEN touch pad.
d. If condition reoccurs, call STERIS.*
Table 7-2. Troubleshooting Chart – Alarm Screen and/or Printout
PROBLEM POSSIBLE CAUSE AND CORRECTION
*Service charges may be incurred. Consult your warranty for details.