Steris RELIANCE 400, Operator'S Manual

Page: 55 / 106

5-3
Cycle and Control Value Programming Operator Manual 122994-513
5.2 Change Values
Mode
Three paths are available to customize cycles to suit specific needs. It
is possible to modify factory pre-set cycles, add or remove cycle treat-
ments or create a personalized cycle configuration (see Figure 5-1).
Change Values mode allows authorized operators to modify or add
treatment values in, or remove from, existing cycles, create new
cycles or modify miscellaneous operating values. Change Values
mode consists of four functions: MODIFY, ADD/CREATE, REMOVE
and EXIT (see Figure 5-2).
NOTE: If access code feature is enabled, operator must enter access
code before entering Change Values mode (see Figure 5-10).
CUSTOM
CYCLE
MODIFY
FACTORY
PRE-SET
ADD
TREATMENTS
CREATE YOUR
OWN
CONFIGURATION
Figure 5-1. Change Values Mode Functions
STATUS
MODIFY ADD
REMOVE EXIT
MODIFY MODIFY MODIFY MODIFY MODIFY
To modify Treatment Values
• Time
• Temperature
• Chemical Injection
Pump
• Chemical Injection
Time*
* Note: Chemical injection
time can be adjusted for
each cycle. Refer to
Cycle Description Chart,
to see default values.
ADD/CREATE ADD/CREATE
ADD/CREATE ADD/CREATE ADD/CREATE
To add treatments to an
existing cycle
To create an original
custom cycle program
EXIT EXIT EXIT EXIT EXIT
To start cycle with fresh
water
To print cycle values
To modify miscellaneous
operating values:
• Printer Enable/Disable
• Date and Time
• Access Code Enable/
Disable
• Lockout cycles
• Water saver
REMOVE REMOVE
REMOVE REMOVE REMOVE
To remove a previously
added treatment from an
existing cycle
Figure 5-2. Change Values Mode – Program Tree