Steris RELIANCE 400, Operator'S Manual

Page: 43 / 106

4-13
Operating Instructions Operator Manual 122994-513
4.6 Extend Cycle
Treatment
Treatment times may be temporarily extended by pressing EXTEND
CYCLE touch pad prior to initiating a cycle during cycle program
review. Temporarily extended treatment times apply only to immedi-
ate selected cycle. On completion of cycle, treatment times return to
programmed settings.
1. Press CYCLE MENU touch pad to scroll through Cycle menus
and press SELECT CYCLE touch pad to select cycle.
2. Press REVIEW CYCLE touch pad to access Review mode. Con-
tinue to press REVIEW CYCLE touch pad to advance screen to
desired treatment. Display shows:
NOTE: Cycle may be started at any point while in Review mode
by pressing
CYCLE/START touch pad.
3. With correct treatment displayed, press EXTEND CYCLE touch
pad. Programmed treatment time is temporarily doubled. If
EXTEND CYCLE touch pad is pressed again, treatment time
returns to original programmed setting. Display shows:
NOTE: While in Review mode, pressing EXTEND CYCLE touch
pad only allows operator to double programmed treatment time. If
a longer treatment time is desired, programmed setting must be
adjusted in Change Values mode prior to starting cycle.
4. Press REVIEW CYCLE touch pad again and repeat procedure
for each treatment for which time is to be extended.
5. Press CYCLE/START touch pad while in Review mode to initiate
cycle. Cycle automatically progresses through each treatment
as temporarily adjusted in Review mode.
IMPORTANT: To run cycle with extended treatment times, cycle
must be started by pressing CYCLE/START touch pad while in
Review mode. If operator reaches PRINT CYCLE VALUES? dis-
play and answers YES or NO without starting cycle first, control
exits Review mode. Display screen returns to the Cycle menu
and any adjustments made in Review mode are erased.
NOTE: Printout generated in Review mode lists programmed (not
extended) treatment values. Extended treatments are identified
on in-cycle printout generated while cycle is in process (see Fig-
ure 4-8).
RINSE1
RECIRC. TIME = 01:00
RINSE1
RECIRC. EXTD = 02:00
CYCLE
MENU
SELECT
CYCLE
REVIEW
CYCLE
* CONTROL ON 7:08:24A
94/03/09
*****************************
RELIANCE
MODEL 400
S/N 0000000000
************************
========================
CYCLE - LIGHT
========================
CYCLE START
8:10:58A
CYCLE DATE 99/03/09
CYCLE NUMBER 0000001
UNIT NUMBER 0000000000
MOTOR SPEED = LOW
TREATMENT TIME
------------------------
PRE-WASH1
8:10:58A
WASH 1 8:21:33A
RINSE 1 8:24:49A
TREAT. EXTEND
RINSE 2
8:28:31A
PURE W.1 8:31:57A
DRYING 8:33:32A
COMPLETED AT 8:48:32A
CYCLE TIME = 0:38:36
========================
= READY TO UNLOAD =
========================
DOOR OPEN
8:51:37A
Extended
Treatment
Figure 4-8. Printout With
Extended Cycle Treatment