Steris RELIANCE 400, Operator'S Manual

Page: 39 / 106

4-9
Operating Instructions Operator Manual 122994-513
4.5 Typical Cycle
Operation
Both glassware washers are equipped with an Eagle
®
3000 Stage 3
Control System, which offers a wide variety of treatment combina-
tions resulting in a large number of possible cycle types.
NOTE: For typical cycle operation, note the following:
1) Washer operation can be halted at any time by pressing STOP/
RESET touch pad. Pressing STOP/RESET touch pad once halts
cycle and printout message says "STOP PRESSED!". Pressing
STOP/RESET touch pad twice aborts cycle and printout mes-
sage is "CYCLE ABORTED!". To resume cycle, press CYCLE/
START touch pad. In an emergency, if it is necessary to open
door after pressing STOP/RESET touch pad, wait for water flow
to stop and then open door. To resume cycle, close door and
press
CYCLE/START touch pad.
2) Review S
ECTION
7, T
ROUBLESHOOTING
, to identify the cause of
any abnormal condition during a cycle, or if unit fails to complete
a cycle.
The following cycle description applies to the preprogrammed
LIGHT cycle , which is the most extensive combination of prepro-
grammed treatments. Refer to Table 5-1 , Cycle Description Chart ,
for default treatment values of the LIGHT cycle.
1. Ensure power switch (located under load side control) is posi-
tioned to ON (refer to Figures 3-1 and 3-2).
2. Position POWER-OFF/STANDBY switch (located behind printer
door) to POWER position. Display shows, for example:
then:
__ indicates flashing position
and printout message is:
* CONTROL ON 7:08:24A
94/03/09
************************************
RELIANCE
MODEL 400
S/N 0000000000
************************************
3. Press CYCLE MENU touch pad to scroll between three Cycle
menus. Press SELECT CYCLE touch pad to select a cycle from
displayed menu (cycle is flashing).
RELIANCE
MODEL 400
LIGHT MEDIUM
HEAVY CYCLE 4
WARNING – BURN HAZARD:
• Except for an emergency, do
not open door when cycle is
in progress. In an emer-
gency, first stop cycle by
pressing STOP/RESET touch
pad and wait for water flow to
stop. Wear appropriate Per-
sonal Protective Equipment
(PPE) whenever reaching
into chamber.
• After pressing STOP/RESET
touch pad, wait until water
flow stops before slowly
opening door. Hot water/
steam may be sprayed
through door opening if
door is opened too soon.
WARNING–PERSONAL INJURY
HAZARD:
• In case of power loss,
power door(s) lowers slowly
by gravity. Keep hands and
items out of door area to
avoid personal injury.
• Risk of pinch point
between door and upper
panel. Do not push on top
portion of doors; do not
push on door when door is
rising; do not push on door
when door is jammed.
CAUTION – POSSIBLE EQUIP-
MENT DAMAGE: Always posi-
tion each manifold and/or
bottom rotary spray over a
manifold connector before
operating unit. If manifolds and/
or bottom rotary sprays are not
positioned correctly, damage
will result and unit will be
unable to effectively wash load.