Steris RELIANCE 400, Operator'S Manual

Page: 38 / 106

4-8
122994-513 Operator Manual Operating Instructions
4.4.3 Universal Shelving
System (Optional) –
Reliance 500
Universal shelving system (See Figure 4-7).
It is possible to remove central section only to accommodate two
loads of small items of glassware on each side (up to 10-1/2"
[260 mm] high) and a load of larger items (more than 10-1/2"
[260 mm] high and up to 25-1/2" [650 mm] high) in the center (see
Figure 4-5).
If a greater loading space is required for larger loads, it is possible to
remove central and right sections.
NOTE: Load must not exceed 25-1/2" (650 mm) high.
To remove central section from universal shelving system (see
Figure 4-7):
1. Press on latch located under central shelf section right corner to
unlock.
2. Put a hand under shelf section spray arm to support and with
other hand, slide section out from wash chamber.
To reinstall central section:
1. Insert flaps on both sides of support into shelf sliding guides.
Ensure manifold connector simultaneously fits into position.
2. Push shelf section to end of chamber and push on right latch to
lock it in place.
To remove right section from universal shelving system:
1. Press on latch located under right shelf section right corner to
unlock.
2. Put a hand under shelf section spray arm to support and with
other hand, slide section out from wash chamber.
To reinstall right section:
1. Insert flap from support into shelf sliding guide. Ensure manifold
connector simultaneously enters into its position.
2. Push shelf to end of chamber and push on right latch to lock it in
place.
NOTE: For the universal shelving system, note the following:
1) Use appropriate support basket and glassware support to
process larger loads when removing shelf sections.
2) Reliance 500 only: Reinstall right section first on universal
shelving system before reinstalling central section.
3) Remove shelf sections before removing entire universal
shelving system from unit.
To remove entire universal shelving system:
1. To remove entire universal shelving system, press safety latch
on left side of shelf, and slide shelf out of wash chamber (see
Figures 4-6 and 4-7).
2. To replace universal shelving system, align shelf with chamber
guides and push shelf into chamber until safety latch locks in
place.