Steris RELIANCE 400, Operator'S Manual

Page: 26 / 106

3-2
122994-513 Operator Manual Component Identification
3.2 Control Location
3.2.1 Power Switch
The power switch – used to shut off power to the unit control board
and I/O board for maintenance purposes. Power switch is located
under load side control (see Figure 3-2).
IMPORTANT: Power switch should remain in ON position at all times
for normal unit operation.
3.2.2 POWER-OFF/STANDBY
Switch
The POWER-OFF/STANDBY switch, located behind the printer
door, includes two settings which direct operation of the control (see
Figure 3-2).
• POWER – press top portion of rocker switch to initialize controls
and place control in Automatic mode. If option applies, pure
water tank fills and begins heating water.
• OFF/STANDBY – press bottom portion of rocker switch to
initiate SHUTDOWN cycle and turn off all ac power to control
(Standby mode).
NOTE: Control should be placed in Standby mode after last cycle
of the day and when glassware washer is not in use for an
extended period of time.
IMPORTANT: Placing POWER-OFF/STANDBY switch to OFF/
STANDBY position DOES NOT turn off electrical power to the
unit.
3.2.3 Printer
The printer records all cycle data on 2-1/4 inch wide, single-ply,
thermal paper. Refer to
S
ECTION
6, R
OUTINE
M
AINTENANCE
, for paper
changing and paper ordering information.
The printer is located inside of load side control panel, to the right of
load door.
Printer Function switch – controls two printer functions, PRINT and
PRINT VALUES :
• PRINT – pressing top portion of rocker switch generates a
complete printout of current water temperature in sump and in
optional pure water tank, and air temperature in drying chamber.
• PRINT VALUES – pressing bottom portion of rocker switch
generates a complete printout of all cycle values.
POWER
OFF
STANDBY
PRINT
PRINT
VALUES