48 S&C Instruction Sheet 1043-550
Category
Event Description
Definition
Log Level
DNP
App layer accepted FIN-only
message (Transport Header,
Fragment Length, Source Address,
N/A)
A multi-frame fragment was successfully processed by the
application layer and is being removed from the transport
function buffers.
All
DNP
App layer accepted FIR-FIN
message (Transport Header,
Fragment Length, Source Address,
N/A)
A single-frame fragment was successfully processed by the
application layer and is being removed from the transport
function buffers.
All
DNP
Change to point map detected
(Map Number 0=binary in
1=analog in 2=counter 3=control
4=analog out, N/A, N/A, N/A)
A configuration change to a point map was detected. This
change will be processed 30 seconds after the last change is
detected.
All
DNP
Frame accepted by DL (Source
Address, Destination Address,
Transport Header, Frame Length)
A single frame was successfully handed off to the data link
layer for transmit. Note that this may be a single frame of a
multi-frame fragment.
All
DNP
Removed old FIR-only message
(Transport Header, N/A, Source
Address, N/A)
An incomplete fragment was discarded due to a newer message
being received from the same source device.
All
DNP
Route config change detected
A configuration change to the routing table was detected. This
change will be processed 30 seconds after the last change is
detected
All
IntelliTEAM
All teams are transfer ready
All teams are fully operational, and may close switches as
necessary to transfer load and reconfigure the circuit.
Normal
IntelliTEAM
Bad received mesg type (Team,
Type)
An IntelliTEAM message was received over communications
but contains a message type that is not recognized. The team
the message was intended for, and the message type received,
are included in the data.
Normal
IntelliTEAM
Bad Volt Reopen Flag (team,
value)
Associated with the “Team Member Requalify Time” feature.
Value of 1 means that the team member is disqualified on an
unsuccessful attempt to close and a timer is started. Value of 0
means that the timer has cleared, and the team member can be
considered as an alternate source again.
Normal
IntelliTEAM
Close switch fail (Team, Sw)
The switch/position indicated failed to close or remain closed
after a request by the specified team. Automatic operation may
have been disabled at this team member, or the switch may
have reopened during the shots-to-lockout time period.
Normal
IntelliTEAM
Close switch ok (Team, Sw)
The switch/position indicated was successfully closed by the
specified team.
Normal
Data Logging
