S&C Instruction Sheet 1043-550
11
Figure 3. PRESENT CONDITIONS Screen.
This screen includes the following fields:
External Device Present Conditions
Switch Position
Once the binary status points are entered for switch position and the Interface Module is
polling the external device, the present switch position will be displayed here. Anything
other than open and close will be reported as bad contacts.
Remote Mode
Once the binary status point is entered for remote mode and the Interface Module is
polling the external device, the state of the remote mode will be displayed here. If not
programmed an N.A. will be displayed.
Fault Status
This field will follow the phase fault status points. If all points are inactive, Normal will be
displayed, Fault Detected will be displayed on any or all points that are active.
Error/Trouble Status
Any active alarms out in Data Logging, Logging Status Points will cause the message
“Problems Present - Check Data Logging Screens”.
Interface Module Present Conditions
Prohibit Restoration
When Prohibit Restoration becomes active from the front panel or from IntelliTEAM II,
Enabled will be displayed, else Disabled will be displayed.
Troubleshooting Problems
