S&C Instruction Sheet 1043-550
31
Team Member Action
Path
The
Team Member Action Path
screen (Figure 9) shows a table of the actions taken dur-
ing the execution of a switch operation. This information is used for diagnostic purposes
when working with S&C support engineers.
Some switch gear require different steps to be taken during the operation of the switch
than other gear. These steps are often further changed by the configuration of switch
parameters, the team parameters, and the conditions of the event. Together the steps are
called the Action Path. The Action Path displayed in this table is created on the fly based
on the present conditions during each event.
Due to the complexity of some Action Paths it is necessary to have the ability to back out
of a series of steps. Backing out of an Action Path may occur when one of the steps can
not be performed, thus requiring that the switch be put back into its normal state.
To display the Action Path screen:
Click the Operation button at any IntelliLINK screen, then click Misc Operation and then
the Action Path buttons.
Figure 11. Team Member Action Path Screen.
This screen includes the following information:
Direction
This is the Forward or Reverse direction that the Action Path is presently taking. Reverse
will only occur if the forward path is stopped before completion.
Action Item Pointer
For diagnostic purposes only, when working with S&C support engineers. This indicates
the record within the Action Path that is presently being executed.
Team Problems
