S&C IntelliTEAM II, Instruction Sheet

Page: 41 / 78

S&C Instruction Sheet 1043-550
41
Here is the list of all events, grouped by Category and Event Description:
Category Event Description Definition Log Level
DNP Cold restart requested (Source
Address, Destination Address,
N/A, N/A) A cold restart of the control has been requested over SCADA,
and will be performed in two seconds. Normal
DNP Configuration change accepted Changes to the communications setup parameters were
validated and have been made active within the application. Normal
DNP DNP Initialization complete Displayed when initialization of DNP processes has completed
without error. Normal
DNP Error in configuration data (Setup
Value, Min Value, Max Value,
N/A) A configuration setup parameter was found to be set
incorrectly or out of range.
Normal
DNP Map change callback init error A DNP point map change callback function was unable
to be registered due to a full callback list. This prevented
initialization of DNP processes from being completed.
Normal
DNP Master record not added (Return
Code 1=error 3=list full, Code
Location, N/A, N/A) The master record was unable to be added to the peer device
list due to either an incorrect parameter or the peer device list
is full.
Normal
DNP Old configuration remains in
effect Indicates that due to an error in configuration data the existing
setup will continue to be used by the application. Normal
DNP Pass-through routing disabled A valid pass-through route configuration was not found and
pass-through routing was disabled. Normal
DNP Pass-through routing enabled A valid pass-through route configuration was found and pass-
through routing was enabled. Normal
DNP Point map init error The point mapping table was unable to be initialized,
preventing initialization of DNP processes from being
completed. Normal
DNP Point map reinitialized (Map
Number, N/A, N/A, N/A) The point map was successfully reinitialized following
completion of changes to the point map configuration. Normal
DNP Route table init error The routing table was unable to be initialized, preventing
initialization of DNP processes from being completed.
Normal
DNP Route table initialized (Count of
Routes, N/A, N/A, N/A) The route table was successfully initialized with configured
routes and routing was enabled.
Normal
Data Logging