Serial Communications
Page 7-7
_________________________________________________________________
Setting Up the Command Protocol
If the remote command mode is used, the following command mode
options may be changed by selecting "Command Mode" under the
"Comm" menu (Figure 7-3):
Figure 7-3 Command Mode Setup Screen
The Command Mode screen allows the protocol to be customized to
a certain extent. Following are descriptions of the items found
on this screen:
Model
2010D
Address
The calibrator address must be assigned a
value between 0 and 255. The calibrator
will only respond to protocol commands if
the address in the command matches the
address entered here. When muti-drop is
disabled, the address field will be
ignored, though it must still be present
in the protocol.
Summary of Contents for 2010D
