Sabio 2010D, Operation Manual

Page: 106 / 182

Serial Communications Page 7-4
_________________________________________________________________
Though these are the most important commands for an auto-answer
application, there are many other options available for special
situations. The modem's instruction manual should be referred
to for more detailed information.
Setting Up the Com Ports
The Model
2010D
can be configured for remote communications by
selecting "Port Setup" under the "Comm" menu and then selecting
either Com1 or Com2. After a com port is selected, the screen
shown in Figure 7-1 will appear.
Figure 7-1 Port Set-up Screen
The following options are available from this screen:
Remote Terminal Enabled
This option must be set to yes to
enable remote terminal mode.
Command Mode Enabled
his option must be set to yes to enable
command mode.
---
NOTE
---
Although most settings in this screen (e.g.
baud rate, etc.) are implemented when the
screen is saved, the Model
2010D
program
must be re-started before changes to the
Remote Terminal Enabled or Command Mode
Enabled options will be implemented. The
system can be re-started by selecting
"Restart Program"