84
<Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
RTN
button or pushing the
Home/Exit
button.
<SensorTouch™>
TIMER
Timer setting
The Timer function may be set for any desired time,
i.e. engine run time, specified times for competitions,
etc. Two independent timers are provided for your use.
The timers are stored independently with each model,
meaning that when you switch between model setups,
the timer associated with the new model is brought up
automatically.
The timers may be set to start and stop from the
motion of any switch or stick. You may set the ON and
OFF directions freely. Each timer has a capacity of up
to 59 minutes 59 seconds.
Timer setting
*Perform the following settings after using the touch sensor
to move the cursor to the item you want to set.
1. Up timer/down timer setting
Move the cursor to the [MODE] item and
touch the RTN button to switch to the data
input mode.
Select the mode by moving the touch sensor
to the left or right and touch the RTN button.
[UP]: Up timer
[DOWN]: Down timer
2. Timer time setting
Move the cursor to the [10]:[100] item and
touch the RTN button to switch to the data
input mode.
Set the time by turning the touch sensor to
the left or right.
[00]:[00]:[min]:[sec]
Touch the RTN button to end adjustment and
return to the cursol move mode.
Each timer may be set for count-down or count
up operation with a target time.
If a target time is set and the timer reaches the set
time, a buzzer sound for each count is generated.
Countdown timers sound one short beep during the
last twenty seconds and two short beeps during the
last ten seconds before reaching the target, then a long
tone at the target time, and continue counting with
displaying a minus (-) sign. Count-up timers also beep
the last twenty and ten seconds, beep the target time,
and keep counting upwards until shut down.
3. Switch setting
Move the cursor to the item of the switch
you want to set, call the switch setup screen
by touching the RTN button, and select the
switch and ON direction.
[For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.]
[RESET SW]: Reset switch
[START SW]: Start switch
[STOP SW]: Stop switch
Timer operation
● Timer 1 and Timer 2 are started/stopped by
pre-selected start/stop switch.
● To reset a timer, operate the pre-selected
reset switch, or move the cursor to the [RESET]
display on the timer screen and touch the
RTN button.
● Select [TIMER] at the linkage menu and call the setup
screen shown below by touching the RTN button.
● The timer value is held even
if the power is turned off or
the model is switched.
Memory
→
ON
●Calling setup screen
Scrolling
● Moving cursor
● Selecting mode
Summary of Contents for FX-32
Page 1: ...Instruction Manual FX 32 No F8078 ...
Page 9: ...9 Introduction Notes ...
