152
<Functions of Model Menu (Helicopter Functions)>
Normal Curve
Idle-up 1 Curve
Idle-up 2 Curve
Hold Curve
●Pitch Curve (Example)
● Group/Single item: When you also want to
input the same setting contents at other
conditions, perform setting in the group
mode. In this case, the same contents are
input to the other conditions set in the group
mode. When you want to set each condition
independently, select the single mode
(initial setting). Other conditions can be set
independently.
Setting method
● Pit trim copy (Hover/high/low)
The pitch trim operating position can be
copied to the pitch curve.
Move the cursor to the [COPY] item and
touch the RTN button.
After copying, return the pitch trim to the
center to call the last operating position.
The screens shown below are curves created
by entering the pitch rate at low, center, and high
side (3 points or 5 points) at each condition. When
actually creating a curve, input the rate specified at
the fuselage (or the reference value).
*For a description of the curve setting method, see the
description at the back of this manual.
Curve setting examples
(Continued on next page)
Pitch Trim (Hovering pitch, high pitch, low pitch)
The hovering pitch, low pitch, and high pitch trim setup screen can be called from the PIT curve setup
screen.
● Hovering pitch
trim setting
● Low/high pitch
trim setting
Summary of Contents for FX-32
Page 1: ...Instruction Manual FX 32 No F8078 ...
Page 9: ...9 Introduction Notes ...
