76
<Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
RTN
button or pushing the
Home/Exit
button.
<SensorTouch™>
SERVO-REVERSE
Use to reverse the throw direction.
Servo Reverse changes the direction of an
individual servo’s response to a control stick
movement.
For CCPM helicopters, be sure to read the
section on Swash AFR before reversing any servos.
With CCPM helicopters, always complete your
servo reversing prior to any other programming.
If you use pre-built Airplane/Sailplane functions
Servo reversing procedure
*After linkage of a new model is complete, check whether or
not each servo is connected to the correct channel.
*Next, determine whether you need to reverse any channels
by moving each stick.
1. Use the touch sensor to move the cursor to
the channel you want to reverse and touch
the RTN button to switch to the data input
mode.
2. Turn the touch sensor and change the
display to [REVERSE] (or [NORMAL]).
*The display blinks.
3. When the RTN button is touched, servo
operation is reversed. (Operate touch sensor
or S1 button to stop reversal.)
*Repeat the operation above for each channel that must be
reversed.
that control multiple servos, it may be confusing
to tell whether the servo needs to be reversed or a
setting in the function needs to be reversed. See the
instructions for each specialized function for further
details. Always check servo direction prior to every
flight as an additional precaution to confirm proper
model memory, hook ups, and radio function.
(The display screen is an example. The screen
depends on the model type.)
● Select [SERVO REVERSE] at the linkage menu and
call the setup screen shown below by touching
the RTN button.
● Touch the
S1
button to
call next page.
Scrolling
● Moving cursor
● Selecting mode
● Push the
S1
button to
call next page.
Summary of Contents for FX-32
Page 1: ...Instruction Manual FX 32 No F8078 ...
Page 9: ...9 Introduction Notes ...
