127
<Model Menu (Airplane/Glider Functions)>
● S e l e c t t h e f u n c t i o n
name and return to the
preceding screen by
touching the
RTN
button
or pushing the
Home/Exit
button.
<SensorTouch™>
RUDDER 2
RUDDER
RUDDER
V-TAIL
RUDDER 2
Winglet
RUDDER 1
Winglet
at Flying wing
at Flying wing
( )
( )
AIL 3
AIL 3
(Chip Aileron)
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
AIL to RUD
[Corresponding model type]: Airplane/glider, general
Use this mix when you want to mix the rudders
with aileron operation.
● A mixing curve can be set.
● Mixing during flight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
● The mixing rate can be fine-tuned by setting a VR.
Setting method
● Move the cursor to the ACT/INH item and
touch the RTN button to switch to the data
input mode.
Turn the touch sensor to the left and touch
the RTN button. (ON is displayed.)
● When setting a switch, move the cursor to
the [--] item of the switch and touch the RTN
button to call the selection screen, and then
select the switch and set its ON direction.
(Always ON at "--" setting)
(For a description of the switch selection
method, see the description at the back of
this manual.
● When setting a VR, move the cursor to the
Fine Tuning "--" item and touch the RTN
button to call the selection screen, and then
select the VR. The adjustment rate can be
set. The VR operation mode can also be
selected.
[Fine tuning VR operation mode]
[LIN.]
Mixing rate 0% at center of VR.
When the VR is turned clockwise and
counterclockwise, the mixing rate
increases and decreases, respectively.
[ATL+]
Mixing rate 0% at left end of VR.
When the VR is turned, the mixing rate
increases.
[ATL-]
Mixing rate 0% at right end of VR.
When the VR is turned, the mixing rate
increases.
[SYM.]
When the VR is turned to the left or
right of the neutral position, the mixing
rate increases.
● Mixing curve setting
*For a description of the curve setting method, see the
description at the back of this manual.
● L e f t / r i g h t o v e r a l l
adjustment at Rate A
and Rate B
(Currently selected condition name)
● Select [AIL to RUD] at the model
menu and call the setup screen
shown below by touching the
RTN button.
● Group/single mode
switching
(For more information, refer to
the description at the back of
this manual.)
*The display screen is
an example. The actual
screen depends on the
model type.
● Fine tuning VR setting
● Adjustment rate
● Operation mode
● A mixing curve can be set.
(For a description of the curve setting
method, see the description at the back of
this manual.)
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
Summary of Contents for FX-32
Page 1: ...Instruction Manual FX 32 No F8078 ...
Page 9: ...9 Introduction Notes ...
