147
<Model Menu (Airplane/Glider Functions)>
● S e l e c t t h e f u n c t i o n
name and return to the
preceding screen by
touching the
RTN
button
or pushing the
Home/Exit
button.
<SensorTouch™>
[Corresponding model type]: Glider, general
CONDIT1
1/3
ELEVATOR
-50 +50
ACCELERATION
● 1/3 Elevator setting
● 2/3 Elevator
→
Camber setting
● 3/3 Aileron
→
Rudder setting
Setting method
● Acceleration rate setting (Rate)
● The return time after operation (Dumping)
can be set.
● The operation point at acceleration
and deceleration can be set. When an
operation point is exceeded, acceleration is
performed.
Note: When using the acceleration funtion,
since the servo stroke is large, make your
settings so there is no binding of your linkage.
(Currently selected condition name)
● Select [ACCELERATION] at the model
menu and call the setup screen shown
below by touching the RTN button.
● Act position
●Current position
Acceleration setting can be performed at
elevator, ELE to Camber and AIL to RUD.(Glider
and EP glider only)
● This setting is divided into elevator setting and
camber setting. The setting method is the same.
● Camber setting sets the acceleration function for
ELE to camber mixing. Setting is not performed
when ELE to camber mixing is INH.
● The acceleration function can be set for both the
up side and down side.
● Function ON/OFF switch setting is performed for AIL
to RUD setting only.
● AIL to RUD setting is acceleration
function setting for AIL to RUD mixing. It is not
performed when AIL to RUD mixing is INH.
CONDIT1
2/3
-50 +50
CONDIT1
3/3
-50 +50
RUD
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
Summary of Contents for FX-32
Page 1: ...Instruction Manual FX 32 No F8078 ...
Page 9: ...9 Introduction Notes ...
