81
<Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
RTN
button or pushing the
Home/Exit
button.
<SensorTouch™>
SWASH RING
Swash ring setting procedure
*Perform the following settings after using the touch sensor
to move the cursor to the item you want to set.
1. Activate the function:
Move the cursor to the [ACT/INH] item and
touch the RTN button to switch to the data
input mode.
Switch the blinking from "INH" to "ACT" by
turning the touch sensor to the left and then
touch the RTN button.
2. Rate setting:
Use the touch sensor to move the cursor
to the [RATE] item touch the RTN button to
switch to the data input mode.
Use the touch sensor to set the rate.
Initial value: 100%.
Adjustment range: 50% to 200%.
*Adjust the rate to maximum swash tilt.
(When the RTN button is touched for 1 second, the rate is
reset to the initial value.)
Touch the RTN button to end adjustment and
return to the cursol move mode.
Limits the swash plate travel to within a fixed range. (Helicopter only)
This function limits the swash travel to within
a fixed range to prevent damaging of the swash
linkage by simultaneous operation of the ailerons
and elevators. It is effective in 3D aerobatics which
use a large travel.
● The operating range display area:
The vertical direction shows the
elevator travel. The horizontal
direction shows the aileron travel.
● The marker shows the
stick position.
● Select [SWASH RING] at the linkage
menu and call the setup screen
shown below by touching the RTN
button.
● When the swash ring function is activated,
a circle is displayed in the operating
range display area and the rate input
box is displayed. Stick operation is limited
to within the area of this circle.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
Summary of Contents for FX-32
Page 1: ...Instruction Manual FX 32 No F8078 ...
Page 9: ...9 Introduction Notes ...
