ROBBE-Futaba FX-32, Instruction Manual

Page: 150 / 180

150 <Functions of Model Menu (Helicopter Functions)>
● S e l e c t t h e f u n c t i o n
name and return to the
p r e c e d i n g s c r e e n b y
touching the RTN button
or pushing the Home/Exit
button.
<SensorTouch™>
MODEL MENU (HELICOPTER)
This section contains information on the
commands that apply to helicopters only. For
instructions on airplanes and sailplanes, refer to the
sections pertaining to those aircraft.
Use the Model Type function in the Linkage
Menu to select the swash type matched to the
fuselage beforehand.
Also, add flight conditions at the Condition
Select screen if necessary before setting the model
data at each function. (Up to 8 conditions can be
used)
The AFR function, dual rate function and other
functions common to all model types, are described
in a separate section.
Model Menu functions (helicopter) list
PIT CURVE: Adjusts response in different flight conditions
THR CURVE:
Throttle curve and hovering trim adjustment
ACCELERATION: Allows a brief "overload" in response to sudden throttle and pitch commands
THR HOLD: Moves the throttle to idle during autorotation
SWASH MIX:
Compensates for each control response
THROTTLE MIX: Compensates for power loss when cyclic applied
PIT to NEEDLE: Adjusts response curve in different flight conditions
PIT to RUD:
Handles torque changes from pitch angle inputs
GYRO: Used to switch gyro sensitivity
GOVERNOR:
Used to switch RPM of the helicopter’s head
To activate/deactivate Condition Hold:
1.Move the cursor to [COND. HOLD].
2.Set the throttle stick lower than
the 1/3 point and touch the RTN
button to activate/deactivate the
condition hold function.
*Refer to for condition hold function details.
*Condition hold operation is displayed.
● Select the [MODEL] at the home screen
and call the model menu shown below by
touching the RTN button.
● Use the touch sensor to select the function
you want to set and call the setup screen by
touching the RTN button.
Scrolling
● Moving cursor
● To next page