ROBBE-Futaba FX-32, Instruction Manual

Page: 130 / 180

130 <Model Menu (Airplane/Glider Functions)>
● S e l e c t t h e f u n c t i o n
name and return to the
preceding screen by
touching the RTN button
or pushing the Home/Exit
button.
<SensorTouch™>
RUDDER 2
RUDDER
RUDDER
V-TAIL
RUDDER 2
Winglet
RUDDER 1
Winglet
at Flying wing at Flying wing
( ) ( )
AIL 3 AIL 3
(Chip Aileron) (Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
RUD to AIL
[Corresponding model type]: Airplane/glider, general
This function is used when you want to mix
the ailerons with rudder operation. It is used
when rudder is applied during roll maneuvers,
knife edge, etc. of stunt planes. It can be used to
bank scale models, large models, etc. like a full
size plane.
● A mixing curve can be set.
● Mixing during flight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
● Linking can be set: Link this mix to other mixes.
● The mixing rate can be fine-tune by setting a VR.
Setting method
● Move the cursor to the ACT/INH item and
touch the RTN button to switch to the data
input mode.
Turn the touch sensor to the left and touch
the RTN button. (ON is displayed.)
● When setting a switch, move the cursor to
the [--] item of the switch and touch the RTN
button to call the selection screen, and then
select the switch and set its ON direction.
(Always ON at "--" setting)
(For a description of the switch selection
method, see the description at the back of
this manual.
● When setting a VR, move the cursor to the
Fine tuning "--" item and touch the RTN
button to call the selection screen and then
select the VR. The adjustment rate can be
set,.
The VR operation mode can also be set.
(For a description of the fine tuning VR setting
method, see the description at the back of
this manual.)
● A mixing curve can be set.
(For a description of the curve setting
method, see the description at the back of
this manual.)
● When linking: move the cursor to the [LINK]
item and touch the RTN button to switch to
the data input mode. Turn the touch sensor
to the left and touch the RTN button. (ON is
displayed.)
● Mixing curve setting
*For a description of the curve setting method, see the
description at the back of this manual.
● L e f t / r i g h t o v e r a l l
adjustment at Rate A
and Rate B
(Currently selected condition name)
● Select [RUD to AIL] at the model
menu and call the setup screen
shown below by touching the
RTN button.
● Group/single mode
switching
(For more information, refer to
the description at the back of
this manual.)
*The display screen is an example. The
actual screen depends on the model type.
● Fine tuning VR setting
● Adjustment rate
● Operation mode
[Fine tuning VR operation mode]
[LIN.]
Mixing rate 0% at center of VR.
When the VR is turned clockwise and
counterclockwise, the mixing rate
increases and decreases, respectively.
[ATL+] Mixing rate 0% at left end of VR.
When the VR is turned, the mixing rate
increases.
[ATL-] Mixing rate 0% at right end of VR.
When the VR is turned, the mixing rate
increases.
[SYM.] When the VR is turned to the left or
right of the neutral position, the mixing
rate increases.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page