131
<Model Menu (Airplane/Glider Functions)>
● S e l e c t t h e f u n c t i o n
name and return to the
preceding screen by
touching the
RTN
button
or pushing the
Home/Exit
button.
<SensorTouch™>
CAMBER MIX
[Corresponding model type]: Airplane/glider, 2 ailerons or more
This function adjusts the AFR (D/R) rate
of camber operation which operates the wing
camber (ailerons, camber flaps, brake flaps) in
the negative and positive directions. The aileron,
flap, and elevator rates can also be adjusted
independently by curve, and attitude changes
caused by camber operation can be corrected.
*Initial setting assigns camber operation to side lever LS.
● The up/down side rates of the aileron, flap, and
elevator servos can be adjusted by curve. When
the mixing direction is reversed by the linkage,
adjustments can be made by changing the
mixing rate polarity (+ or -).
● Mixing during flight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
● A delay can be set for each condition. A cut
switch which can turn OFF the delay function can
be set.
● The speed of the aileron, flap, and elevator servos
can be set. (IN side/OUT side)
●Condition delay
cut switch
●Condition delay
setting
● Camber AFR (D/R) setup screen call
(For a description of the setting method, refer to
the AFR function.)
● Servo speed setting
(For a description of the setting
method, see the description at
the back of this manual.)
●Overall adjustment by
Rate A and Rate B
●Aileron rate
adjustment
(Currently selected condition name)
● Select [CAMBER MIX] at the model
menu and call the setup screen
shown below by touching the RTN
button.
● Mixing curve setting
*For a description of the curve setting method, see the
description at the back of this manual.
*The display screen is an example. The actual
screen depends on the model type.
(Curve/rate setting screen)
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
Summary of Contents for FX-32
Page 1: ...Instruction Manual FX 32 No F8078 ...
Page 9: ...9 Introduction Notes ...