ROBBE-Futaba FX-32, Instruction Manual

Page: 160 / 180

160 <Functions of Model Menu (Helicopter Functions)>
● S e l e c t t h e f u n c t i o n
name and return to the
p r e c e d i n g s c r e e n b y
touching the RTN button
or pushing the Home/Exit
button.
<SensorTouch™>
THROTTLE MIX
This function corrects slowing of engine speed
caused by swash plate operation during aileron
or elevator operation. The method of applying
clockwise or counterclockwise torque when
pirouetting can also be corrected.
An acceleration function which temporarily
increases the throttle side correction rate relative to
rapid stick operation can also be set.
When correction is necessary, move the cursor
Setting example
● AIL to THR applies a load to the engine and
corrects slowing of the engine speed when
the aileron stick was operated. Engine
racing can be adjusted independently at
the right aileron and left aileron by Rates A
and B.
Setting method
● When using this function, move the cursor to the [ACT]
item and touch the RTN button to switch to the data
input mode. Turn the touch sensor to the left and
touch the RTN button. (ON is displayed.)
● When you want to set the same contents at other
conditions, select the group mode.
When you want to set the selected condition only,
select the single mode (initial setting).
● The correction rate can be set by curve.
● A switch can be set.
When [ [--]] is set, the swash mixing function is
operated by merely selecting the condition.
When setting an [ON]/[OFF] switch, move the cursor
to the [--] item and touch the RTN button to call
the selection screen and set the switch and its ON
position.
to the mixing item corresponding to the mixing
that needs correction and touch the RTN button to
call the curve setup screen, and then correct the
slowing.
<Acceleration function setting>
● Acceleration can be set for both
settings (Left) and (Right)
● Acceleration rate setting (Rate)
● The return time (Dumping) after
operation can be set.
● The operation point when the
c o r r e c t i o n r a t e i s i n c r e a s e d
a n d d e c r e a s e d c a n b e s e t
independently. When an operation
point is exceeded, acceleration
operation is performed.
(Currently selected condition name)
● Select [THROTTLE MIX] at the model
menu and call the setup screen shown
below by touching the RTN button.
● G r o u p / s i n g l e m o d e
switching
(For more information, refer to
the description at the back of this
manual.)
● Mixing curve setting
*For a description of the
curve setting method,
see the description at the
back of this manual.
●Acceleration settings
Scrolling
● Moving cursor
● Selecting mode
● To next page