133
<Model Menu (Airplane/Glider Functions)>
● S e l e c t t h e f u n c t i o n
name and return to the
preceding screen by
touching the
RTN
button
or pushing the
Home/Exit
button.
<SensorTouch™>
ELE to CAMBER
[Corresponding model type]: Airplane/glider, 2 ailerons or more
This function is used when you want to mix the
camber flaps with elevator operation. When used,
the flaps are lowered by up elevator, and lift can
be increased.
Note: Tailless wing elevator can be operated
when this mix is activated.
● A mixing curve can be set.
● Mixing during flight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
● The mixing rate can be fine-tuned by setting a VR.
● Ailerons and flaps rate
adjustment
1. Select the rate box and
touch the RTN button to
switch to the data input
mode.
2. Adjust the rates by scrolling
the touch sensor.
3. Touch the RTN button to
end adjustment and return
to the cursol move mode.
Setting method
● Move the cursor to the ACT/INH item and
touch the RTN button to switch to the data
input mode.
Turn the touch sensor to the left and touch
the RTN button. (ON is displayed.)
● When setting a switch, move the cursor to
the [--] item of the switch and touch the RTN
button to call the selection screen, and then
select the switch and set its ON direction.
(Always ON at "--" setting)
(For a description of the switch selection
method, see the description at the back of
this manual.)
● When setting a VR, move the cursor to the
Fine tuning "--" item and touch the RTN button
to call the selection screen, and then select
the VR. The adjustment rate can be set.
The VR operation mode can also be
selected.
● A mixing curve can also be set.
(For a description of the curve setting
method, see the description at the back of
this manual.)
● Group/single mode
switching
(For more information,
refer to the description at
the back of this manual.)
● Overall adjustment by
Rate A and Rate B.
(Currently selected condition name)
● Select [ELE to CAMBER] at the model
menu and call the setup screen shown
below by touching the RTN button.
● Mixing curve setting
*For a description of the
curve setting method,
see the description at the
back of this manual.
*The display screen is an example.
The actual screen depends on the
model type.
● Fine tuning VR setting
● Adjustment rate
● Operation mode
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
Summary of Contents for FX-32
Page 1: ...Instruction Manual FX 32 No F8078 ...
Page 9: ...9 Introduction Notes ...
