154
<Functions of Model Menu (Helicopter Functions)>
● S e l e c t t h e f u n c t i o n
name and return to the
p r e c e d i n g s c r e e n b y
touching the
RTN
button
or pushing the
Home/Exit
button.
<SensorTouch™>
THR CURVE/THROTTLE HOVER TRIM
THR Curve
This function adjusts the throttle operation curve
for each condition for optimum engine speed to
throttle stick movement.
Up to 17 curve points can be set for the point
curve type, however, when the 5 points and other
point data is used, a simple curve can be easily
created by reducing the number of input points of
the curve to 5 and entering the specified value at
the corresponding points.
Normal curve adjustment
● Normal curve creates a basic curve
centered around hovering. Use it along
with the normal pitch curve and adjust so
that up/down control at a constant engine
speed is easiest.
Idle up curve adjustment
● Set a idle up curve that maintains a constant
speed at all times, even during operation
which reduces the pitch performed in flight.
Create a curve matched to loop, roll, 3D,
or other purposes and the idle up curve
according to the performance.
Operation precautions
WARNING
When actually starting the engine and flying,
always set the idle up condition switch to OFF
and start the engine in the idling mode.
Setting method
● Group/single item: When you want to
simultaneously enter the same settings to
other functions, make the settings in the
group mode. In this case, the same setting
contents are entered to the all conditions.
When you want to set each condition
independently, make the settings after
selecting the single mode (Initial setting).
● Throttle hover trim copy
The throttle hover trim operating position can
be copied to the throttle curve.
Move the cursor to the [COPY] item and
touch the RTN button.
After copying, return the pitch trim to the
center to call the last operating position.
(Currently selected condition name)
● Select [THR CURVE] at the model menu
and call the setup screen shown
below by touching the RTN button.
● Mixing curve setting
*For a description of the curve setting
method, see the description at the back
of this manual.
● Throttle hover
trim copy
● Throttle hover trim operating
position (dotted line)
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
Summary of Contents for FX-32
Page 1: ...Instruction Manual FX 32 No F8078 ...
Page 9: ...9 Introduction Notes ...
