80
<Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
RTN
button or pushing the
Home/Exit
button.
<SensorTouch™>
IDLE DOWN
Lowers the engine idling speed.(airplane and helicopter only)
The Idle Down function lowers the engines idle
by flipping a switch with the throttle stick at idle.
The action is not functional at high throttle to avoid
accidental dead sticks. The switch’s location and
direction must be chosen, as it defaults to NULL.
Idle down setting procedure
*Perform the following settings after using the touch sensor
to move the cursor to the item you want to set.
1. Activate the function:
Move the cursor to the [ACT/INH] item and
touch the RTN button to switch to the data
input mode.
Switch the blinking from "INH" to "ACT" by
turning the touch sensor to the left and then
touch the RTN button.
2. Switch setting:
Move the cursor to the [SWITCH] item, call
the switch setup screen by touching the
RTN button, and select the switch and ON
direction.
(For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.)
3. Offset rate setting:
Move the cursor to the [OFFSET] item and
touch the RTN button to switch to the data
input mode.
Adjust the servo offset rate at idle down
operation by turning the touch sensor to the
left or right.
Initial value: 0%
Adjustment range: -100%~100%
(When the RTN button is touched for 1 second, the offset rate
is reset to the initial value.)
*Maximum offset amount is near maximum slow.
*When a minus rate is input, offset is applied to the high side.
Touch the RTN button to end adjustment and
return to the cursol move mode.
● Select [IDLE DOWN] at the linkage menu and call
the setup screen shown below by touching the
RTN button.
● Current throttle position
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
Summary of Contents for FX-32
Page 1: ...Instruction Manual FX 32 No F8078 ...
Page 9: ...9 Introduction Notes ...
