Ricoh FT4460, Service Manual, Page: 327 / 413

28 February 1989
9. JOGGER
9.1 JOGGER UNIT REMOVAL
NOTE: Before removing the jogger unit, place a mark along the front edge
of the bottom plate. This is so that the unit can be reinstalled in the
same position, to maintain side-to-side registration.
1. Remove the rear cover (4 screws) and disconnect the three connectors
[A] of the jogger unit.
2. Remove the front cover (2 screws) and the lower inner cover [B] (4
screws). If the multi-duplex unit is installed, remove the “E1” knob [C] in
order to remove the inner cover (1 collar screw).
3. Mark the original position of the jogger unit [D] on the bottom plate [E].
4. Remove two screws from the front of the jogger section. Lift “D1” lever [F]
and pull out the jogger unit.
NOTE: a) When reassembling, rotate the jogger section drive gear [G] and
the tension gear [H] in order to check for backlash. Correct any
backlash by shifting the jogger unit drive gear bracket.
b) Make sure that the distance between the jogger side plate [I] and
the front edge [J] of the copier is 62.4mm as shown.
5-111