Ricoh FT4460, Service Manual, Page: 206 / 413

28 February 1989
NOTE 3:
1. 1st Feed Roller Drive Section
* Grease G501
a) Clean the shaft [A] and the inside
of the idle gears [B]. Then lubri-
cate them with Grease G501
every 120K.
NOTE 4:
1.
a)
b)
Jogger Section
* Mobil Temp 78
Remove the shaft holders [A].
Clean the positioning roller shafts
[B] and shaft holders. Then, lubri-
cate them with Mobil Temp 78
every 120K.
5.2 REPLACEMENT POINTS
Replace the following parts at PM, if
figures:
NOTE 5:
1. Fusing Unit
a) Replace the following three gears
located on the rear side of the
fusing unit every 180K, if neces-
sary.
A: Hot Roller Gear [P/N AB013132]
B: Idle Gear [P/N AB013133]
C: Exit Roller Gear [P/N AB013134]
necessary, as shown in the following
4-46