Ricoh FT4460, Service Manual, Page: 283 / 413

28 February 1989
4.11 LIFT MOTOR REPLACEMENT
1. Remove the rear and right covers (10 screws).
2. Disconnect the 3P connector (white) [A] of the manual feed sensor, and
remove the paper feed control board [B] (1 screw).
3. Disconnect the 2P connector (white) [D] of the pick-up solenoid [C].
4. Disconnect the 3P connector (brown) [E] of the 1st cassette lift sensor.
5. Remove the spring [F].
6. Remove the pick-up solenoid bracket [G] (4 screws).
7. Remove the spring [H].
8. Disconnect the 2P connector (green) [J] of the lift motor [I].
9. Remove the E ring [L] holding the lift motor bracket [K].
10. Separate the bracket from the lift motor [I] (2 screws).
5-67