Ricoh FT4460, Service Manual, Page: 297 / 413

28 February 1989
6.4 TRANSFER/SEPARATION CORONA WIRE
REPLACEMENT
1. Remove the transfer/separation (T/S) corona unit.
2. Remove the following parts:
T/S unit front end block cover [A]
T/S unit rear end block cover [B]
T/S unit paper guide [C].
NOTE: When replacing the T/S unit paper guide, verify that all three tabs are
properly latched in place [D].
3. Unhook the springs [E] from the wires.
4. Replace the transfer corona wire [F] and the separation corona wire [G].
5. Check the position of the mylar strip [H].
NOTE: The transfer mylar is positioned by a jig at the factory. Adjustments
are not normally necessary.
5-81