Ricoh FT4460, Service Manual, Page: 277 / 413

28 February 1989
4.5 2ND FEED ROLLER AND FRICTION PAD REPLACEMENT
1. Remove the first separation guide plate [A] (2 screws).
2. Remove the paper feed roller bracket [B] (1 screw).
CAUTION: Be careful not to drop the spacer [C], spring [D], or bushing [E].
3. Remove the paper feed roller [F] from the shaft, and replace the roller.
4. To remove the friction pad assembly [G], press down on the bottom plate
raising arm [H], and replace the friction pad [I] (1 screw).
NOTE: a) Clean the bracket with solvent before attaching the new friction
pad to its bracket with the 2-sided adhesive tape.
b) When replacing the friction pad, make sure that the gap between
the edge of the bracket and the surface of the pad is within 0.05
to 0.35 mm.
c) After replacing the friction pad, adjust the friction pad pressure.
5-61