Ricoh FT4460, Service Manual, Page: 285 / 413

28 February 1989
4.13 REGISTRATION CLUTCH REPLACEMENT
1. Remove the rear cover (2 screws).
2. Lower the I/O control PCB (1 screw).
3. Disconnect the 2P connector (yellow) [A] of the registration clutch [B].
4. Remove the connecting plate [C], and the registration clutch bracket [D]
(3 screws).
5. Separate the registration clutch from the bracket (1 screw).
6. Remove the idle gear shaft assembly [E] and replace the registration
clutch.
NOTE: When reassembling, make sure that the positioning notch [F] on the
clutch fits over the arm extending from the registration clutch
bracket [G].
5-69