Ricoh FT4460, Service Manual, Page: 146 / 413

28 February 1989
13. Push up the lock lever [A]; then, grasp the handle [B] of the color
development unit and pull the color development unit out half way.
Release the lock lever [A] and pull the color development unit out until it
stops.
14. Grasp the holding band [C] and remove the color development unit while
pushing up the lock lever [A]. Place it on a clean sheet of paper.
NOTE: a) Do not place any metal objects such as screws near the
development unit.
b) Do not touch the surface of the entrance seal [D] or the
development roller [E].
15. Remove the development guide [F] (6 screws).
16. Pour one pack of 4460 type color developer [G] into the color develop-
ment unit while turning the knob [H] counterclockwise to distribute the
developer.
NOTE: a) For easy pouring of the developer, make a small diagonal cut in
the pack as shown.
b) Pour in the color developer required by the customer. (Red, blue
and green developer are available.)
c) Wrap a cloth around the shaft of a magnetized screw driver to
pick up spilled developer.
d) Make sure there is no developer on the entrance seal.
17. Remount the development guide.
3-7