Ricoh FT4460, Service Manual, Page: 227 / 413

23 May 1989
1.8 SCANNER DRIVE WIRE REPLACEMENT
1.8.1 Wire Removal
1. Remove the following covers and parts.
Sorter (if installed)
Control panel
Upper inside cover
Rear cover
Optics cooling fan cover [K] (2 screws) Contact glass
Upper cover
ID sensor pattern plate [J]
Left cover
Right cover
2. Loosen the front and rear first scanner wire clamp screws
3. Remove the front and rear wire tightener springs [B].
4. Loosen the front and rear wire fixing plate screws [C].
5. Remove the 1st scanner home position sensor connector
[A] .
[D] .
6. Remove the scanner wires [E] and [F] from the drive pulley.
7. Remove the scanner wire [H] from the left side plate
8. Remove the scanner wire [I] from the drive pulley.
9. Remove the drive pulley [G].
5-11